Panasonic released firmware update v1.33 for 4K Studio Camera AK-UCX100. It includes support of ST2110 JPG XS, improved network connectivity, expanded intercom functional as well as several bug fixes and improvements.
   

Panasonic AK-UCX100 v1.33 firmware includes:

1. Added Native format to SYSTEM FORMAT

Related MENU BASIC CONFIG > FORMAT

[ FREQUENCY : 59.94Hz ]

2160/29.97p, 2160/23.98p

1080/29.97p, 1080/23.98p

[ FREQUENCY : 50Hz ]

2160/25p, 1080/25p

2. Support of ST2110 JPEG XS

Related MENU BASIC CONFIG > OPT MODE : ST2110 JPG XS

Added related items to IP SIGNAL > ST2110 COMMON menu

3. Support of LAN TRUNK (Ethernet)

Related MENU BASIC CONFIG > LAN(RJ45) MODE : TRUNK

4. Added menu for fine-tuning GAMMA

Related MENU GAMMA / BLACK GAMMA

> OFFSET GAMMA : -10 to +10

5. Intercom function expansion

5-1) Added a mode where the TALK destination can be switched using the hardware switch on the back of the unit.

5-2) The "Zoom Demand" PROD/ENG selection switch operation has been changed to switch the TALK destination of the INCOM1 headset.

5-3) Fixed a bug where INCOM TX/RX could not connect to ENG/PROD correctly when using ST2110/JPEG XS.

Changed the menu name to indicate whether the signal is ENG or PROD.

After      INCOM1 TX (ENG) / INCOM1 RX (ENG)

INCOM2 TX(PROD) / INCOM2 RX (PROD)

6. Supports 31-bit subnet mask

The IP address for LAN, SFP1, and SFP2 can now be set to 31 bits, "255.255.255.254".

7. When an IP address was assigned via DHCP, the display would sometimes remain at the default setting (192.168.0.30) regardless of the valid IP address value. This has been improved.

8. Fixed a problem where USB media devices formatted on the AK-UCX100 main unit could not be read on a Mac.

9. Fixed a bug where the SUB VIDEO TX video was abnormal when OUTPUT SELECT was VF/RET/RET1-4 in ST2110/JPEG XS.

As a result, SUB VIDEO TX will be fixed to CAM output.

10. Supports warning when the clock is not set

11. Supports SFP signal level display when ST2110/JPEG XS

12. Fixed a bug where the error log display on the web screen would show "CAM Sensor Error" even when there was no error

13. Other minor issues have been improved.

Please visit Panasonic’ site to download AK-UCX100 v1.33 Firmware Update.